£7.37 (£8.84 Including VAT at 20%)

Coloured Gels, Gelatine Colour Filter Sheet, Heat resistant, gelatine coloured filters for spotlights and lighting effects. Supplied in 530mm x 600mm (21" x 24") sheets. Available in the following colours

• Mauve 339 / 126
• Light Blue 118
• Dark Blue 120
• Green 124
• Deep Blue 119
• Turquoise 116
• Middle Rose 110
• Yellow 102
• Amber 104
• Orange 105
• Primary Red 106
• Straw Tint 013

To order please select the colour you require and add to the shopping cart - repeat the process for each colour your require. 

£2.23 (£2.68 Including VAT at 20%)

SAFETY BOND, 400mm in length, 2mm diameter.

£2.23 (£2.68 Including VAT at 20%)

MR16 12V 50W PAR 16 SPOT lamp, 12°beam angle, GX5.3 Base, 50mm diameter. For other: Beam angles, Colours, and wattages please contact us.

£8.02 (£9.62 Including VAT at 20%)

PAR 16 BIRDIE Barn Doors

£30.81 (£36.97 Including VAT at 20%)

Low Voltage transformer for use with 12V halogen lamps such as Par 16 Birdie's.

• Pre-wired 12v, dimmable electrical transformers.
• Full VDE certification for low voltage and EMC.
• Fitted with soft start, which prolongs the life of the lamp
• Short-circuit and overload protection, the transformer will shut off automatically in the case of short circuit or overload, after removing the cause of the short circuit or overload the transformer will start to supply the load again.
• In the event of over temperature the transformer will cut the load by means of a thermal fuse.
• European manufacture
• CE marked, VDE Approved.
• Input Mains: 220 to 240VAC 50Hz

• Loading must be in the range of 75 to 200 Watts  (200VA max)

• Additional notes when installing.

  • The maximum distance between the transformer and the 12 volt lamp must not exceed two metres.
  • The transformer must not be positioned closer than 200mm to the lamp.
  • The transformer must not be positioned near central heating pipes or covered with insulation.
  • All the transformers may be installed with suitable dimming equipment.
  • One 200 watt transformer will operate 4 x 50 watt 12 volt halogen lamps. 
  • Use the same lengths of cable between each lamp and the transformer - so voltage drops are equal..
  • The lamps should be wired in parallel.
  
  Find Out More

£2.59 (£3.11 Including VAT at 20%)

IEC Plug, Rewireable IEC hot plug with solder / screws terminations and cable strain relief. Complies with UL, CSA & IEC320 standards. Ratted 10A, 250VAC. Ideal for connections between professional lighting equipment and sound chasers.