Furman PS-8RE II Power Sequencer, All Furman power sequencers feature 3 delayed power groups for sequenced power up, reverse sequence for power down and 2 unswitched outlets. Also has overvoltage detection and mains filtering. The PS-8RE is a 10 Amp unit, has 3 groups of 2 IEC outlets, rear BNC for optional gooseneck light and 1 (unswitched) IEC outlet on the front panel.

Features

• SMP+ (Series Mode Protection Plus) non-sacrificial surge suppression the most comprehensive protection available anywhere!
• LiFT (Linear Filtering Technology) with zero ground contamination
• Extreme Voltage Shutdown
• BNC connector on the rear panel allows for attachment of a gooseneck lamp to illuminate the rear of your rack (models GN-I, GN-LED)
• Power-up in three delayed outlet groups
• Power-down reverses sequence
• Power Status LED’s indicate which outlet groups have power
• Rated 15 amps
• Remote option allows turn-on and turn-off at a distance simply by connecting a momentary or maintained contact switch (and LED if desired)
• Four remote configurations: 12V = ON, 12V = OFF, Rem to GND = ON, and Momentary. (See page 5)
• Multiple units may be linked to handle higher currents and/or more than three delay groups
• Three pairs of switched outlets on rear panel
• Three non-delayed switched outlets (one front, two rear)
• Circuit breaker
• Ten foot heavy duty A.C. cord
• Three year limited warranty

Specification

• Maximum Load: PS-8R IIE: 10 amps (2300 watts at 230 VAC)
• Operating Voltage: 180 to 280 VAC
• Over Voltage Shutdown: 260 VAC typically
• Delay Interval: 5 seconds (adjustable with internal trim pot)
• Remote Switch: Momentary or maintained action.
• Remote Terminal: Screw terminals or Euro style pluggable. Terminal Block, 2 for switch, 2 additional for optional LED (22 ga. wiring minimum).
• Spike Protection Modes: Line to neutral, zero ground leakage
• Spike Clamping Voltage: 376 Vpk (266 VAC RMS)
• Response Time: 1 nanosecond
• Maximum Surge Current: 6,500 amps
• Dimensions: 1.75” H x 19” W x 10.5” D.
• Weight: 12 lbs.
• Construction: Steel chassis, .125” brushed and black anodized aluminum front panel; glass epoxy printed circuit boards
• Power Consumption: 11 watts
• Optional: 220/240V Versions are intended for use in countries with nominal 220 to 240 volt AC mains. Their rear panel outlets use internationally accepted IEC-320 connectors.
• Safety Agency Approvals: NRTL-C, CUL, CE listed.

IEC Plug, Rewireable IEC hot plug with solder / screws terminations and cable strain relief. Complies with UL, CSA & IEC320 standards. Ratted 10A, 250VAC. Ideal for connections between professional lighting equipment and sound chasers.

1 meter IEC Extension lead, 10 Amp Rated fitted with moulded IEC Plug and Female IC Socket, Ideal for connections between professional Lighting and Audio Equipment.

0.5 meter IEC Y Splitter lead / Y cord, 5 Amp Rated , Ideal for Multiple connections between professional Lighting and Audio Equipment. Fitted with moulded IEC Plug and 2 Female IC Sockets, Distance from Y 0.5M